The price of air mill can crush the raw materials into ultra-fine powder, and then continue to screen the fine powder into coarse powder, fine powder and ultra-fine powder with different particle size levels. The surface area of raw materials treated by the gas flow mill will increase, which further improves the physical effect or chemical reaction speed of raw materials, thus increasing its application value. It is widely used in chemical industry, minerals, metallurgy, abrasives, ceramics, refractories and new materials. Therefore, there are many people who use it, and it brings great advantages to people. They have learned its maintenance methods and its maintenance methods. Do you know what to do when the price of air mill starts? Let's take a look with Xiaobian.
Before starting the air mill, please manually roll the rotor to check whether the jaw, hammer and rotor work flexibly and reliably, whether the shell collides and whether the rotation direction of the rotor is consistent with that of the rotor. The direction of the machine arrow. The smoothness of the grinder is not very good. If the speed is too high to cause explosive crushing in the crushing chamber, or the speed is too low to affect the operation efficiency of the crusher, do not replace the pulley at will. After startup, the jet mill shall idle for 2-3 minutes, and then operate after there is no abnormal appearance. In the process of operation, always pay attention to the working state of the crusher, and the feed rate must be uniform to prevent the stuffy car from blocking, and do not overload the work for a long time. If there are signs of vibration, noise, excessive temperature of bearing and body or spraying materials, shut down the machine immediately for inspection, and continue the operation after troubleshooting.